LW's ZEUS MVD DAQ Page

effect of boundary conditions for installation
zeus-daq requirements:
effects of boundary conditions as set by physics groups and the si-detector working group (see design specs ) on the daq/trigger:
front-end electronics:
- necessity for rad hard electronics
- binary vs analog statement.
- information about the binary ABCD chip

Heidelberg : projects and ASIC-LABOR notes
HELIX chip ( User Manual )
Irradiation setup in Utrecht, as used for irradiating an HELIX 1.1 chip in sept 1997 and the results of the analysis

The use of the CAN bus at NIKHEF with documentation about CANopen.
Links and Information to Fieldbus Systems
A project plan for the activities at NIKHEF. See also more detailed cooling information by Jaap Kuyt and the decision table and state transition diagram . The state transition diagram of the Temperature Sensors is standard for a CAN node. Nikhef answers on the questions at the MVD-SC meeting on July 9 are given here (see also the copies of all transparancies).
SC HardStop device
What is a State Transition Diagram ?
Pictures of NIKHEF Can Node and Sensor Module ( specification ) as developed for DATCHA. A possible block scheme for ZEUS is shown here . This information was outdated by the new information above.
Pictures of the cooling set-up in the Jade Hall.

requirements for a possible solution for the ZEUS MVD and a first concept of a project plan (updated march 1999) for the NIKHEF activities concerning an analogue copper link between detector and veto-wall area.
other documentation: H1 (see also NIM A372(1996)188), CMS
Cable arrangement for barrel and wheel combo cables (created nov 1999 and updated later).
Spool for the combo cable during installation of the ladder.
Wheel cabling and feedthroughs inside the MVD.
Pictures of the ADC crate (front and back side)
Requirements for isolated power.

Information sent to Janet Frasier concerning cabling for the Slow-Control connections and the analogue links (updated Jul 8/Aug 25 1999).