Copyright (c) Nikhef. All rights reserved.
On this page the testing of the Velo upgrade is displayed.
Displacement measurement due to cooling.
- Prototype RED substrate module, narrow hurdle.(Dutch)(PDF)
This is the latest deformation test done at Nikhef for the plan A. This is done with a different size dummy substrate.
- Presentation Velo Upgrade workshop 29 may-2015(PDF)
- Extend rapport of testing & results (Dutch)(PDF)
- Prototype module 1 - Complete rapport (Dutch)(PDF)
- Prototype module 2 - Complete rapport (Dutch)(PDF)
- Prototype module 3 - Complete rapport (Dutch)(PDF)
Documents last updated 19-09-2017
Development of Plan Z.
- Heating/Cooling of C side when 30 W is set over the Tile heater(wmv)
- Heating/Cooling of N side when 30 W is set over the Tile heater(wmv)
- Forced dryout on a part of the substrate withouth restrictions(Z2_2_1)(wmv)
- Forced dryout on a part of the substrate with very heavy restrictions(Z2_1_1)(wmv)
The dryout is achieved by reducing the flow, while the module is heated at higher power then normal. After dryout is achieved the flow is gradualy increased to a the nominal flow to restore the cooling.
Documents last updated 21-09-2017
General Research.
- Trying to remove the conncetor from the midplate by applying heat(mp4) This was unsuccefull. The substrate was desolderd from the connector.
Documents last updated 4-10-2017