Start SAG comp logging
- Adjust SAG comp to 50, 90 en 50 % of the value for the layer in progress
- Lower the spacer according the next procedure.:
* spindles West half turn up
* spindles East one turn up
* spindles West half turn up
* Perform a Rasnik run and check
* spindles West half turn up
* spindles East half turn up
* Perform a Rasnik run and check
* spindles West quarter turn up
* spindles East quarter turn up
* Perform a Rasnik run and check
* spindles West quarter turn up and loose
* spindles East quarter turn up and loose
* Adjust SAG comp to the value for the layer in progress minus 0.1 Bar
* Decouple crane support
* Perform a Rasnik run and check