Production RIGHT Module Support

More pictures Right Detector see: Production Right Detector

(january 9, 2007)
About 60 groundsprings (goldplated CuBe) are bended.

(march 3, 2006)
Bart is checking al electrical connections of the heaters and PT100's.

(febr 24, 2006)
We have mounted a real Module on several places on the Module Support and found out that fits smooth with a small pressure at the 'right clamp foot'. All slots of the Module Support are within the tolerance (14.005 - 14.010). We measured that the sleeve of the right clamp foot np31-01-141 is 5 micron to biq; 14.005 in case of 13.992 - 14.000 which result that we needed a little pressure at this foot to fit this into the slot.

(febr 17, 2006)
23 heaters (of 24) are glued with Araldit 2011 into the Module Support.

(februari 8, 2006)
The right module support is successfully pre-installed in the vacuum vessel. We found some problems but all of them are solvable.

See all pictures

(febr 6, 2006)
Assemby of the module support to the Hood with the 'temporary supports'.

(febr 2, 2006)
3D measurement of the RIGHT module support by Berend Munneke. Measuring results : PDF, hpgl

(jan 11, 2006)
Final machining of the 'right module support' is started by Johan Kos at NIKHEF.

(dec 21, 2005)
All 'cable click connections' are placed in the pre-machined Right Module Support. Everything fits. A cable is placed at the 'longest routing'.

(dec 19, 2005)
Premachining of the Right Module Support is finished at the VU and will be final machined at NIKHEF. The 'cable click connections' (for both detector halves) are finished and at NIKHEF.