OT Installation Database
Module Location
The scope of this page is to give access to the detailed information
about the
location of the OT modules
resulting from the installation procedure.
The
design of the
OT Modules foresees four types of modules:
- S2 (closest to beam-pipe, "A" side)
- S3 (closest to beam-pipe, "C" side)
- S1 (next to S2 and S3)
- F (all others)
During the
module production,
serial numbers have been
assigned to each module, providing full tracing to the
module components,
as well as to the
production Quality Monitoring and Checks.
During the detector installation, the position of each module in the detector
was recorded: click on the
drawing below
to access the "location" table of each C-frame.
Given the
detector layout,
the position of each module in the detector is identified according to the
OT naming conventions.
For each position the following information is recorded:
-
Module Type (F | S1 | S2 | S3)
-
Module Serial number (assigned during module production)
- one serial number per F module
- two serial numbers (Upper & Lower) per S module
-
Mono-layer "A" Serial number (assigned during module production)
- one panel serial number per F mono-layer
- two panel serial numbers (Upper & Lower) per S mono-layer
-
Mono-layer "B" Serial number (assigned during module production)
- one panel serial number per F mono-layer
- two panel serial numbers (Upper & Lower) per S mono-layer
-
Which mono-layer ("A" or "B") is closer to the interaction point
- either "A" or "B" for F modules
- any combinations ("AA" | "AB" | "BA" | "BB") for S modules
(Upper & Lower)
The complete database of the information so far recorded can be found
here.